Article List
- Why Do Forged Parts Have Better Performance Than Those Produced by Turning And Casting?When it comes to forging, designers are no strangers. Some students say that only large-sized parts (such as when suitable specifications of bars are not available in the market), or complex shaped parts (such as when all machining is too wasteful of material), will they think of forging. In fact, w
- Basic Introduction To Steel Plates1. Introduction to steel plates:Steel plate is one of the four major varieties of steel (plate, tube, shape, and wire). With the development of China's national economy, the production of steel plates is gradually increasing. Steel sheet is a flat steel plate made by pouring molten steel, cooling it
- Spray molding is a widely usedSpray molding is a widely used metal surface treatment technology, which is popular in fields such as hardware, home decoration, and building materials.Spray molding is the process of delivering powder coatings stored in containers to the nozzle through compressed air. High voltage static electricit
- The Noise of Spur Gear TransmissionUnder the same conditions, the noise of spur gear transmission is usually greater than that of helical gears. The reasons are as follows:1. * * meshing method * *: The tooth surface of a spur gear is in instantaneous contact during meshing, and the impact force between the tooth surfaces is relative
- The main difference between AT10 and T10The main difference between AT10 and T10 synchronous belts lies in their tooth profile and transmission characteristics.1. Tooth type difference: The bottom of the tooth type of the AT10 synchronous belt is a circular arc tooth, while the T10 synchronous belt has a full ladder tooth. The difference
- Drive MotorThe drive motor, as the core of new energy vehicles, is a key component of the entire drive motor. The motor shaft is used to fix the rotor iron core and achieve torque transmission. Whether its processing quality meets the standard will directly affect the performance of the vehicle's power system.
- Common Methods for Micro Inspection of Gear Surfaces1、 Common methods for micro inspection of gear surfaces1) Profile tooth shape and tooth direction lead detection.pictureTraditional gear quality inspection can only be used to analyze faults related to low order harmonics.2) FFT detection of tooth surface using Fourier transform.Using Fast Fourier T
- Welding Process To Reduce Welding DeformationThe methods for preventing and reducing welding deformation must consider welding process design and overcoming changes in cold and hot cycles during welding. Shrinkage cannot be eliminated, but it can be controlled. There are several ways to reduce shrinkage deformation.1. Do not weld excessivelyTh
- Which Cars Have Gear Shafts?Which cars have gear shafts?The input shaft or gear shaft is usually located in manual cars.Do automatic cars also have gear shafts?yes. However, it depends on the working mode of the automatic transmission system. For example, a car equipped with a Titanic transmission (automatic manual transmissio
- Why Can't The Number of Teeth on A Gear Be Less Than 17?As an important component in mechanical transmission systems, gears need to follow many principles and standards in their design and manufacturing to ensure their normal operation and long-term durability. In gear design, the selection of the number of teeth is a key factor. The limitation that the